Unisar Baby Monitor AC401-2P User Manual

0

Out of 0 Ratings

Owner's of the Unisar Baby Monitor AC401-2P gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 48
 
SETTING UP YOUR MONITOR
SENSOR PAD (See figs. 1 and 2)
Place the Sensor Pad under the center of the crib mattress with the turquoise side facing up.
Do not place any loose bedding or linen between the crib mattress and the Sensor Pad.
The Sensor Pad must rest on a flat, firm surface. If your crib has a spring or slat base, place a
piece of plywood or Masonite under the Sensor Pad. This support must measure at least 13
inches long on all four sides and
1
/4 inch thick. (You may order a Masonite board directly from
us. See Pg. 22). If your crib has a plywood base, your mattress support is firm enough to use
the monitor properly.
Only use your Angelcare
®
monitor in a stationary sleeping environment such as a crib where
the Sensor Pad can rest on a flat, firm surface. Be sure to place the turquoise side of the
Sensor Pad facing up.
CAUTION: To avoid potential strangulation accidents resulting from loose cords or wires in
the crib, make sure the Sensor Pad cord passes underneath the mattress entirely. After
positioning the Sensor Pad under the mattress, bring the cord to the corner of the crib and
secure it to the top and bottom of the leg of the crib, or wind it around the leg (see fig. 1).
Sensor Pad Sensor Pad
CORRECT
INCORRECT
PLACEMENT OF SENSOR PAD CORD
CORRECT
Sensor Pad Centered Turquoise Side Up
INCORRECT
Sensor Pad Off Center
INCORRECT
Sensor Pad Turquoise Side Down
POSITION OF SENSOR PAD UNDER MATTRESS (Top Down View of Crib)
fig. 2
fig. 1
4

   Find Your Products By Category