Unisar Baby Monitor AC401-2P User Manual

0

Out of 0 Ratings

Owner's of the Unisar Baby Monitor AC401-2P gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 48
 
Sound and Vibration Alarms (See fig. 19)
If no movement is detected by the Sensor Pad, you have the option to have
a sound alarm, a vibration alarm, or both.
1. Press the Menu button until the Sound and/or Vibration symbols appear.
2. Use the Arrow buttons to make your selection. If you want only a sound
alarm, the Sound symbol will appear. If you want only a vibration alarm,
the Vibration symbol will appear. If you want both alarms, both the
Sound and Vibration symbols will appear.
3. Press the Select button when your desired setting appears.
4. Press the Menu button for the next option or press the Exit button to end programming.
NOTE: The vibration alarm will not work when the battery level is low on the Parents’ Unit.
You will know when the battery level is low because the Low Battery Indicator will appear and
the unit will beep. The vibration alarm also will not work when the Parents’ Unit is in the
Charging Base.
Room Temperature Control (See fig. 20)
The temperature of your baby’s room is always displayed on the Parents’
Unit. The Room Temperature Control, however, is an optional feature. When
you activate this feature you can set your desired temperature range for
your baby’s room. If the temperature goes above or below the range you
have set, the High or Low Temperature symbol will flash and three beeps
will be heard every four seconds.
If the Temperature Control alarm does go off, you can temporarily turn it
off for two minutes by pressing the Power button. The symbol will continue to flash but the
beeping will stop. The alarm will begin again after two minutes unless the room temperature
returns to your preset range or you turn the Temperature Control feature off. The preset
Temperature Control range is 59º-86ºF.
To set the temperature range:
1. Press the Menu button until the High Temperature and Low Temperature symbols appear.
2. “ ” or “ ” will appear. Use the Arrow buttons to turn it on.
3. Press the Select button.
4. Press the Menu button.
5. The Low Temperature symbol will flash. Using the Arrow buttons, select the lowest
temperature you want the nursery to reach.
6. Press the Select button.
7. Press the Menu button.
8. The High Temperature symbol will flash. Using the Arrow buttons, select the highest
temperature you want the nursery to reach.
9. Press the Select button.
10. Press the Menu button to change another feature setting or press the Exit button to end
programming.
If you choose to turn the Room Temperature Control off, the nursery temperature will still be
displayed on the Parents’ Unit; however, it will not alert you if the temperature is outside your
desired range.
fig. 19
fig. 20
10
OF

   Find Your Products By Category