Garmin Marine GPS System GPSMAP User Manual

0

Out of 0 Ratings

Owner's of the Garmin Marine GPS System GPSMAP gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 132
 
118 GPSMAP
®
6000/7000 Series Owner’s Manual
Appendix
Setting Decimal Precision for NMEA 0183 Output
You can adjust the number of digits to the right of the decimal point for transmission of NMEA
output.
1. From the Home screen, select
Congure > Communications > NMEA 0183 Setup > Posn.
Precision.
2. Select
Two Digits, Three Digits, or Four Digits.
Setting Waypoint Labels for NMEA 0183 Output
You can congure how the chartplotter provides waypoint identiers.
1. From the Home screen, select
Congure > Communications > NMEA 0183 Setup > Waypoint
IDs.
2. Select
Names or Numbers.
Resetting NMEA 0183 Communication Default Settings
You can reset NMEA 0183 settings to their default values.
From the Home screen, select Congure > Communications > NMEA 0183 Setup > Defaults
> OK.
Viewing NMEA 0183 Diagnostic Information
The NMEA 0183 Diagnostics screen is a troubleshooting tool used by installers to verify that NMEA
0183 data is being sent across the system.
From the Home screen, select Congure > Communications > NMEA 0183 Setup >
Diagnostics.
NMEA 2000
GPSMAP 6000/7000 series chartplotters are NMEA 2000 certied and can receive data from a
NMEA 2000 network installed on the boat to show specic information on the Information screen,
such as depth, speed, water temperature, wind speed and direction, and engine data.
To connect a GPSMAP 6000/7000 series chartplotter to an existing NMEA 2000 network and to
see a list of supported NMEA 2000 PGN numbers, see the GPSMAP 6000/7000 Series Installation
Instructions.
Viewing a List of NMEA 2000 Network Devices
You can view the devices connected to the NMEA 2000 network.
1. From the Home screen, select
Congure > Communications > NMEA 2000 Setup > Device
List.
2. Select a device for a list of options.
Selecting a Preferred Data Source
If more than one data source is available, you can select the data source you want to use.
1. From the Home screen, select
Congure > Communications > Preferred Sources.
2. Select a type of data.
3. Select
Change Source.
4. Select a data source.

   Find Your Products By Category