Bosch Power Tools Saw Bosch Power Tools Saw User Manual

0

Out of 0 Ratings

Owner's of the Bosch Power Tools Saw Bosch Power Tools Saw gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
-6-
Operating Instructions
To prevent serious personal injury, always disconnect the plug for the power source before changing wheels, or
making any adjustments on the tool.
1. Raise wheel guard as shown in (Fig. 3), push in spindle lock
(Fig. 1), and loosen the hex head bolt in the center of abrasive
wheel by rotating counter-clockwise with the wrench provided.
2. Remove the hex head bolt, outside flange and abrasive wheel
(Fig. 3).
3. Carefully install the new abrasive wheel onto the spindle shaft
and replace outside flange and hex head bolt.
4. Press in spindle lock and tighten hex bolt with the wrench
provided (ATTENTION: DO NOT OVERTIGHTEN).
Whenever replacing a wheel, always adjust the
depth stop bolt to prevent the wheel from
cutting into the surface the tool is resting on. Failure to make this
adjustment may result in serious personal injury.
Removing and Installing Wheels
TRIGGER SWITCH WITH “LOCK-ON” BUTTON
Your tool can be turned “ON” or “OFF” by squeezing or
releasing the trigger. Your tool is also equipped with "Lock-ON"
button, located on the left side of the trigger handle, that allows
for continuous operation without holding the trigger. The “Lock-
ON” is a convenience for long cutting operations.
NOTE: Switch can accommodate a padlock with a shackle of
up to 3/16” in diameter (not provided with tool) to prevent
unauthorized use.
TO LOCK SWITCH ON: Squeeze trigger, depress button and
release trigger.
TO UNLOCK THE SWITCH: Squeeze trigger and release it
without depressing the “Lock-ON” button.
If the “Lock-ON” button is continuously being
depressed, the trigger cannot be released.
WARNING
!
WARNING
!
WARNING
!
"LOCK-ON" BUTTON
TRIGGER SWITCH
SPINDLE
SHAFT
WHEEL
GUARD
INSIDE
FLANGE
RETAINING
RING
ABRASIVE
WHEEL
OUTSIDE
FLANGE
HEX HEAD
BOLT
ADAPTER
(THICKER)
SPACER
(THINNER)
DEPTH STOP
ADJUSTMENT BOLT
LOCK NUT
FIG. 2
FIG. 3

   Find Your Products By Category