Alpine Car Stereo System In-Dash GPS Navigation Receiver User Manual

3.6

Out of 1 Ratings

Owner's of the Alpine Car Stereo System In-Dash GPS Navigation Receiver gave it a score of 3.6 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    1.0 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    4.0 out of 5
of 101
 
69-EN
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of INA-W900 (AUX mode) or to the BLUETOOTH Interface
connector by using an optional Conversion cable (KCE-237B)
(AUX+ mode), follow the procedure described below.
1
Press SOURCE/ on the unit.
The SOURCE selection screen is displayed.
2
Touch [AUX]*
1
or [AUX+].
The external input screen is displayed.
3
Touch [NTSC/PAL]*
2
to change the video input
type.
*
1
The name that is given as the source name in “Setting the AUX
Mode” on page 55 is displayed.
*
2
Cannot be performed in AUX+ mode.
•
.
If the AUX mode is not displayed on the main menu, set AUX IN to
ON by following
“Setting the AUX Mode” (page 55).
• If the AUX+ source is not displayed on the main menu, set AUX+ IN
to ON by following
“Setting the AUX+ Mode” (page 55).
• The display mode changes by touching [WIDE] for AUX mode.
For operation, refer to “Switching Display Modes” on page 46.
Auxiliary Device
(Optional)
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the Video while driving the vehicle.
The driver may be distracted from looking ahead and
an accident could occur.
Install the INA-W900 correctly so that the driver
cannot watch Video unless the vehicle is stopped and
the emergency brake is applied.
If the INA-W900 is not installed correctly, the driver
will be able to watch the Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.
To activate your auxiliary devices:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the AUX mode operation has been
released. Engaging the parking brake can reactivate the AUX
mode, as long as the car’s ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
“To activate your auxiliary devices.”
Each time the ignition is turned OFF, perform the procedure of “To
activate your auxiliary devices.”
•
If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.

   Find Your Products By Category