Dacor Refrigerator EF36LNBSS User Manual

0

Out of 0 Ratings

Owner's of the Dacor Refrigerator EF36LNBSS gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 48
 
3
Location Requirements
Your Dacor refrigerator can be recessed in an opening between
cabinets or installed at the end of a cabinet run using a side panel
to enclose the refrigerator.
IMPORTANT:
Observe all governing codes and ordinances.
It is recommended that you do not install the refrigerator near
an oven, radiator, or other heat source.
Do not install in a location where the temperature will fall
below 55°F (13°C).
Floor must support the refrigerator weight, more than 600 lbs
(272 kg), door panels and contents of the refrigerator.
Ceiling height must allow for side tipping radius. See Tipping
Radius.
Location should permit doors to open fully. See Door Swing
Dimensions.
Location must permit top grille removal. See Opening
Dimensions.
Opening Dimensions
To avoid tipping during use, the solid soffit must be within 1”
(2.5 cm) maximum above the refrigerator. If the solid soffit
is higher than 1” (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the
rear wall studs 80” to 90” (203 cm to 229 cm) above the floor.
See Install Anti-Tip Boards for more information.
NOTE: A clearance of ¹⁄2” (1.3 cm) must be maintained above
the top grille in order for the top grille to be removed.
Tools and Parts
Tools needed:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Cordless drill
Drill bits
Two adjustable wrenches
Phillips screwdriver
Small level
Appliance dolly
Torx
®†
T15 and T27 screwdrivers
¹¹⁄ 32” nut driver
³⁄ 8” and ¹⁄2” open end wrenches
Allen wrench (
5
⁄32”)
¹⁄
4” and
5
/16” socket drivers
Tape measure
Utility knife
PARTS NEEDED:
Six #8 x 3” (7.6 cm) wood screws (longer screws may be
needed)
One or two 2” x 4” x 32” (5 cm x 10 cm x 81 cm) wood
board(s)
For IF36 models, consult a qualified cabinetmaker or carpenter
to make the panels. See the Installation Requirements section
for more information. EF36 models are equipped with stainless
steel finished doors and are shipped complete.
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
¹⁄
4” (6.35 mm) compression fitting.
Installation Requirements
†
TORX is a registered trademark of Textron Innovations Inc.
"
(1.3 cm)
1
/2
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.

   Find Your Products By Category