4.0

Out of 2 Ratings

Owner's of the Horizon Fitness Waterskis CT81 gave it a score of 4.0 out of 5. Here's how the scores stacked up:
  • Reliability

    4.0 out of 5
  • Durability

    4.0 out of 5
  • Maintenance

    3.5 out of 5
  • Performance

    4.5 out of 5
  • Ease of Use

    4.0 out of 5
of 19
 
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
ASSEMBLY STEP 3
FLAT WASHER (B)
CONSOLE MAST
CONSOLE CABLE
SPRING WASHER (H)
BOLT (G)
CONSOLE
DO NOT ATTACH
THIS SIDE UNTIL STEP 3-D
FLAT WASHER (D)
CONSOLE MAST
CONSOLE CABLES
SPRING WASHER (G)
BOLT (H)
CONSOLE
DO NOT ATTACH
THIS SIDE UNTIL STEP 3-D
FLAT WASHER (B)
20 mm
Qty: 4
SPRING WASHER (H)
15 mm
Qty: 4
BOLT (G)
20 mm
Qty: 4
HARDWARE BAG 3 CONTENTS :
A Open HARDWARE BAG 3.
B With running deck in lowered position, place CONSOLE on upright masts. Align the brackets
that are underneath the console with the top holes of the upright masts.
C To assemble the CONSOLE to the LEFT CONSOLE MAST, insert 1 BOLT (G),
1 SPRING WASHER (H) and 1 FLAT WASHER (B) into the 2 holes in the
LEFT CONSOLE MAST and lightly tighten.
D Gently lift RIGHT side of the CONSOLE to connect the CONSOLE CABLE. Carefully tuck wire
in mast to avoid damage. NOTE:
E Repeat STEP C above to assemble the RIGHT CONSOLE MAST to the CONSOLE.
F Leave console bolts loose until after STEP 4 is completed.
ASSEMBLY STEP 4
BOLT (I)
CONSOLE MAST
BOLT (G)
CONSOLE MAST
CROSS BAR
SUPPORT BAR
BOLT (I)
15 mm
Qty: 4
HARDWARE BAG 4 CONTENTS :
OA pen HARDWARE BAG 4.
AB lign SUPPORT BAR with holes in CONSOLE MASTS.
IC nsert BOLTS (I) into all 4 holes of the SUPPORT BAR.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
TD ighten all console bolts (Step 3) and support bar bolts (Step 4) completely.
CT81_Treadmill_Rev.1.8.indd 10-11 5/29/07 8:51:33 AM