Global Machinery Company Air Compressor AC24L User Manual

4.2

Out of 22 Ratings

Owner's of the Global Machinery Company Air Compressor AC24L gave it a score of 4.2 out of 5. Here's how the scores stacked up:

  • Reliability

    4.32 out of 5

  • Durability

    4.14 out of 5

  • Maintenance

    4.14 out of 5

  • Performance

    4.05 out of 5

  • Ease of Use

    4.5 out of 5
of 16
 
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is
missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has
been rectified. Failure to do so could result in serious
personal injury.
Assembly
The handle of the AC40L model must be fitted in the
following manner:
1. Loosen the grub screw in each of the handle fixing
holes.
2. Insert the two ends of the handle into the fixing holes.
3. Tighten the grub screws to secure the handle in place.
Wheels
Fit the wheels as follows:
• for the 24 litre compressor, push each wheel firmly onto
the axle until it "snaps" into position.
• for the 40 litre compressor, first insert an axle pin
through the wheel and then through the hole in the
bracket under the tank. Next, fit the spacer on the axle
pin followed by the flat washer, split washer and nut.
Tighten the nut. Repeat for the second wheel.
Rubber feet
Fit the two rubber feet on the bracket on the front
underside of the tank using the screws, washers and nuts
supplied.
Warning. The air compressor must be filled with oil before
first use.
To prevent possible spillage of oil during transport, the
compressor oil is supplied in a separate container. It must
be added to the compressor before turning the compressor
on. Failure to add the oil will cause non-repairable
damage to the compressor and will void the warranty.
1. Remove the plastic oil filling cap (15) located on the
top of the crank case of the compressor housing.
2. Use the oil supplied to fill the crank case until the oil
level as seen in the oil level glass (17) is up to the mid
point of the red circle.
3. Replace the oil filling cap (15). Ensure the cap is fully
fitted and firmly in position.
10

   Find Your Products By Category