Delta Saw ts200ls User Manual

3.5

Out of 7 Ratings

Owner's of the Delta Saw ts200ls gave it a score of 3.5 out of 5. Here's how the scores stacked up:

  • Reliability

    3.43 out of 5

  • Durability

    3.43 out of 5

  • Maintenance

    3.29 out of 5

  • Performance

    3.71 out of 5

  • Ease of Use

    3.43 out of 5
of 27
 
20
Fig. 39A
A
C
B
Fig. 39B
B
or more to one side or the other depending on which
miter gage slot is being used. This auxiliary wood-facing
(B) can be fastened
to the front of the miter gage by
using two wood screws (C) through the holes provided
in the miter gage body and into the wood-facing.
NEVER USE THE FENCE AS A CUT-OFF
GAGE WHEN CROSS-CUTTING.
When cross-cutting a number of pieces to the same length, a
block of wood (B) Fig. 39B can be clamped to the fence and
used as a cut-off gage as shown in Fig. 39B. It is important that
this block of wood always be positioned in front of the saw
blade as shown. Once the cut-off length is determined, secure
the fence and use the miter gage to feed the work into the cut.
This block of wood allows the cut-off piece to move freely
along the table surface without binding between the fence and
the saw blade, thereby lessening the possibility of kickback and
injury to the operator.
WHEN USING THE BLOCK (B) FIG. 39B,
AS A CUT-OFF GAGE, IT IS VERY IMPORTANT THAT
THE REAR END OF THE BLOCK BE POSITIONED SO
THE WORK PIECE IS CLEAR OF THE BLOCK BEFORE
IT CONTACTS THE BLADE.
Ripping is cutting lengthwise through a board. The rip
fence (A) Fig. 40 is used to position and guide the work.
One edge of the work rides against the rip fence while
the flat side of the board rests on the table. Since the
work is pushed along the fence, it must have a straight
edge and make solid contact with the table.
THE SAW BLADE GUARD MUST BE
USED. ON DELTA SAWS, THE GUARD HAS ANTI-
KICKBACK FINGERS TO PREVENT KICKBACK AND
A SPLITTER TO PREVENT THE WOOD KERF FROM
CLOSING AND BINDING THE BLADE. BE SURE TO
REPLACE OR SHARPEN THE ANTI-KICKBACK
DEVICES WHEN THE POINTS BECOME DULL.
A RIP FENCE SHOULD ALWAYS BE
USED FOR RIPPING OPERATIONS. NEVER
PERFORM A RIPPING OPERATION FREE-HAND.
RIPPING
1. Start the motor and advance the work holding it down
and against the fence. Never stand in the line of the
saw cut when ripping. When the rip width is 6 inches
or wider, hold the work with both hands and push it
along the fence and into the saw blade (Fig. 40). The
work should then be fed through the saw blade with
the right hand. Only use the left hand to guide the
workpiece. Do not feed the workpiece with the left
hand. After the work is beyond the saw blade and
anti-kickback fingers, remove hands from the work.
2. When this is done the work will either stay on the
table, tilt up slightly and be caught by the end of the
rear guard, or slide off the table to the floor.
Alternately, the feed can continue to the end of the
table, after which the work is lifted and brought
along the outside edge of the fence. The cut-off
stock remains on the table and is not touched until
the saw blade has stopped, unless it is a large piece
allowing safe removal. When ripping boards longer
Fig. 40
A
Fig. 41

   Find Your Products By Category