Craftsman Saw 137.248830 User Manual

3.8

Out of 26 Ratings

Owner's of the Craftsman Saw 137.248830 gave it a score of 3.8 out of 5. Here's how the scores stacked up:

  • Reliability

    3.88 out of 5

  • Durability

    3.69 out of 5

  • Maintenance

    3.81 out of 5

  • Performance

    3.85 out of 5

  • Ease of Use

    3.65 out of 5
of 31
 
SAW MOUNTED TO WORK SURFACE (FIG. C)
1. If the leg set will not be used, the saw must be
properly secured to a sturdy workbench using the four
mounting holes at the base of the saw.
2. The surface of the table where the saw is to be
mounted must have a hole large enough to facilitate
sawdust fall-through and removal.
3. Square the saw on the mounting surface and mark
the location of the four 3/8" mounting holes (1).
4. Drill four 3/8" holes into the mounting surface.
5. Mark an 11" square (2) centered between the four
mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fall through the
saw base.
8. Place the saw on the work surface, and align the
mounting holes of the saw with those drilled through
the surface.
9. Fasten the saw to the work surface.
14WARNINGI
Do notoperatethismachine on thefloor.Thisisvery
dangerousand may causeseriousinjury.
Fig,C
BLADE RAISING HANDWHEEL (FIG. E, F)
1. Attach the handwheel (1) to the elevation screw (2)
at the front of the saw.
Make sure the slots (3) in the hub of the
handwheel engage with the pins (4). (Fig. E)
2. Attach and tighten the dome nut (5) at the end of the
shaft (Fig. F).
Fig. E
3 2 4
t
O
O
14WARNINGI
Failure to provide the sawdust fall-through hole will cause
sawdust to build up in the motor area, which may result in
fire or cause motor damage,
Place the dust bag neck opening around the dust
chute and tie the dust bag with string.
BLADE TILTING HANDWHEEL (FIG. G, F)
1. Attach the other handwheel (6) to the blade tilting
screw on the side of the saw in the same manner as
above.
2. Attach and tighten the handwheel dome nut (5).
Fig. F

   Find Your Products By Category