Braun Electric Shaver FLEX XPII User Manual

3.8

Out of 1 Ratings

Owner's of the Braun Electric Shaver FLEX XPII gave it a score of 3.8 out of 5. Here's how the scores stacked up:

  • Reliability

    4.0 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    3.0 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    4.0 out of 5
of 22
 
8
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Charging light (green)
7 Cleaning light (yellow)
8 Special cord set
Charging the shaver
• Using the special cord set, connect the
shaver to an electrical outlet. Allow it to
charge for at least 8 hours. During charging
shaver and special cord set might get
warm.
• With normal use the shaver will be charged
automatically after every cleaning in the
Clean&Renew™ (see section B).
• The green charging light indicates that the
shaver is being charged.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 60°F to 95 °F / 15°C to 35°C.
• When fully discharged, you may also shave
with the shaver connected to an electrical
outlet via the special cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Keeping your shaver in top
shape
Cleaning indicator
Your shaver should be cleaned daily in the
Clean&Renew™, and certainly when the yellow
cleaning light shines constantly after shaving. If
this is not done, the yellow light will go out after
some time. The shaver‘s electronics will then
assume it has been cleaned manually and a
new calculation of the time when the next
cleaning is required will be started.
During the cleaning process in the
Clean&Renew™ the yellow light will flash and
go off after approx. 4 hours when cleaning is
finished.
Automatic cleaning
Once the shaver is put into in the
Clean&Renew™, it is cleaned automatically
(see section B). Manual cleaning is
recommended only when the Clean&Renew™
is not available, e.g. when traveling.
Manual cleaning
Remove the shaver foil (shaver head must be
in central position) and, using the brush, clean
the cutter block and the inner area of the
shaver head. Do not clean the shaver foil with
the brush.
When cleaning the shaver under running
water, make sure it is completely dry before
putting it into the Clean&Renew™.
Tips for the perfect shave
• It can take up to 14-21 days for your beard
t
o adjust to the new shaving system.
• Shave before washing your face or taking a
shower, as skin tends swell after washing.
• The dryer the skin, the closer the shaving
results will be.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance,
replace your foil and cutterblock every
18 months or when worn.
A The Shaver
5722300_Flex700_NA_6-24 Seite 8 Montag, 13. Juni 2005 10:31 10

   Find Your Products By Category