Alpine CD Player CDA-9833 User Manual

3.8

Out of 15 Ratings

Owner's of the Alpine CD Player CDA-9833 gave it a score of 3.8 out of 5. Here's how the scores stacked up:

  • Reliability

    3.69 out of 5

  • Durability

    3.8 out of 5

  • Maintenance

    3.87 out of 5

  • Performance

    4.07 out of 5

  • Ease of Use

    3.73 out of 5
of 45
 
7-EN
Display Tilt Adjustment
The movable display may be adjusted to 3 different tilt angles
depending upon user preference.
Press TILT 98 to adjust the tilt angle of the movable
display.
• The display will close a half minute after the ignition key is turned
to the OFF position.
• The adjusted tilt angle of the display is stored in memory. There is
no need to re-adjust the tilt angle when the power is turned back on
.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.
Changing the Display Type (CDA-9833 only)
There are three selectable display types. You can also deactivate the
display.
Press DISP/B.OUT to switch the display type.
TYPE1 → TYPE2 → TYPE3 → OFF → TYPE1
TYPE1 : The indicator on the left changes in a fixed sequence.
TYPE2 : The indicator on the left changes according to the
setting (see "Setting the Multicolor Illumination" on
page 23).
TYPE3 : The indicator on the left changes according to audio
level.
Switching the Display modes (CDA-9835
only)
You can select the display pattern mode from three display patterns.
Press DISP/B.OUT to select the desired display
pattern mode.
Each press changes the display patterns.
Basic display of each source → Animation display pattern1 →
Animation display pattern2 → Basic display of each source
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press (Release) at the upper left side until the
front panel pops out.
3
Grasp the left side of the front panel and pull it out.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
•To protect the front panel, place it in the supplied carrying case.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
•Attach the front panel carefully. Hold the panel by its sides to avoid
pushing any buttons by mistake.
Movable display
2
1
1

   Find Your Products By Category