Acoustic Research Speaker System HT60 User Manual

0

Out of 0 Ratings

Owner's of the Acoustic Research Speaker System HT60 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 58
 
page 6
Assembling the Wireless Speaker Stand
The speaker stand comes in two
parts, with the speaker wire already
threaded through both poles. Please
be careful when unpacking to ensure
that the wire remains threaded dur-
ing assembly. To assemble the
speaker stand:
1. Attach the Top Pole to the
Threaded Bottom Pole by twist-
ing the Locking Sleeve Nut over
the bottom pole.
2. Attach the speaker pole to the
Receiver Base. The pole is a key
fit and will only turn in one
direction.
3. Tighten the pole to the Receiver
Base using the supplied Hex
Nut.
4. Attach the speaker by inserting
the top of the speaker rod
through the holes on the back of
the speaker. The top of the rod
should be flush with the top of
the speaker.
5. Connect the Speaker Wire using
the proper polarity (positive to
positive, negative to negative).
NOTE: When properly assem-
bled, the speaker wires should
run through the center of the
stand assembly, with one end
coming out through the hole near
the top and the other end through
the bottom of the receiver.
NOTE: Move the rubber grom-
met to adjust the height of the
speaker stand.
LR
DCIN
ON OFF
LINK
AUDIO
OFF
HT60
Hex Nut
Threaded
Speaker Wire
Speaker Wire
Receiver Base
Surround Speaker
Locking Sleeve Nut
Rubber Grommet
Upper/Top Pole
FIGURE 4 - Speaker
Stand Assembly
Bottom Pole

   Find Your Products By Category