3Com Network Router Unified Gigabit Wireless PoE Switch 24 User Manual

0

Out of 0 Ratings

Owner's of the 3Com Network Router Unified Gigabit Wireless PoE Switch 24 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 40
 
24 Preparing the Managed Access Points
Preparing the 7760
Access Point
If you are not familiar with accessing the 3Com 7760 Web interface, refer
to the 7760 Access Point Quick Start Guide.
1 Log on to the access point Web interface.
2 Check the serial number on the back of the access point.
If the serial number starts with BA/ or higher, a managed image is already
installed. You can skip steps
3 and 4 and go directly to step 5.
3 Ensure the 7760 Stand-alone firmware version is 1.5.25 or greater.
a View the firmware version on the Management -> Firmware
Upgrade page.
b Upgrade the Stand-alone firmware if required.
Get the latest firmware by visiting www.3Com.com. Select Support &
Downloads then Downloads & Drivers and enter the model
number (3CRWE776075).
c Use the Management -> Firmware Upgrade page and set Image
Type to Stand-alone to load the Stand-alone firmware.
4 If the serial number of your access point is not BA/ or higher, you must
load a Managed firmware image to the access point.
a Get the Managed firmware image by visiting www.3Com.com,
selecting Support & Downloads then Downloads & Drivers and
entering the model number (3CRWE776075).
b On the 7760, use the Management -> Firmware Upgrade page
and set Image Type to Managed to load the Managed firmware.
c Click the Upgrade button.
5 Change the access point Start-up Mode from Stand-alone to Managed
using the System Configuration -> System Properties page.
6 Click the Apply button. The access point will reboot automatically.
7 To make the access point active on your Unified Switch 24, see
“Activating the Managed Access Points” on page 21.
Note: After the access point is in Managed mode, it can no longer be
accessed using WIDMan, HTTP, Telnet, or SNMP. An access point in
Managed mode can only be discovered and managed by the 3Com
Unified Switch
24. To return the access point to the default Stand-alone
mode, refer to
“Resetting Access Points” on page 26 of this Quick Start
Guide.

   Find Your Products By Category